Module 1: Report Assignment - Measurement

Module 1: Report Assignment -Measurement (worth 10 points maximum)

This assignment supports the following objectives:

• Solve simple problems using derived quantities (CLO2)(CLO5)
  
• Recognize and use SI Base Units and Prefixes (CLO2)(CLO5)
  
• Convert from one unit system to another. (CLO2)(CLO5)
• Use dimensional analysis to check the consistency of your work. (CLO5)

Lab Report Assignment Instructions:

1. Complete the Module 1: Activity Assignment- Measurement 

2. Complete Module 1: Report Assignment- Measurement using the format below

3. Upload the completed Activity Assignment using the file upload tool below

4. Upload the Report Assignment using the file upload tool below

Lab Report Format:

TITLE: Module 1: Report Assignment- Measurement and Error

YOUR NAME:

ABSTRACT:

• What you did (Explain the Procedure that you followed)
• How you did it (Give the tool and/or "simulator URL" used)
• Why you did it (What was the purpose for doing this experiment)
• What you found (Discuss the quality of your data based on the size of percent error values if you have any and/or Discuss something that you figured out about how the values in your data change as you manipulate the simulator)

VOLUME DATA:    Make a table showing your volume data (use metric units only)

MASS DATA:  Make a table showing your mass data (use metric units only)

VOLUME ANALYSIS: Make a table showing your volume analysis calculations. Show ALL formulas and steps for each calculation in your table. Also, include this conversion factor in your table. 1mL = 1 cm³ (use metric units only)

MASS ANALYSIS:  Make a table showing your mass analysis calculations (use metric units only)

CONCLUSION: What did you learn, not what you did using the simulator (Explain a concept, skill, tool, or formula that you learned as a result of doing this experiment). Also, explain why you never got zero percent error.